Basic HTML Version
37
6. Drive truck under auger discharge and set
brakes.
7.
Starting:
a.
Start the tractor and run at low idle.
b. Place the hydraulic circuit in detent. En-
gage the PTO.
c. Increase the engine RPM to mid-range.
d. Pull and hold the roller control lever.
e. Engage the wheel drive pop valve con-
trol.
f. Set the speed using the flow control. Do
not exceed the loading capacity of the
system.
g. Increase engine RPM to rated speed if
desired to provide an even flow of grain.
Fig. 35 POSITIONING
Fig. 36 CONTROLS
IMPORTANT
It is recommended that 2 people be
involved when operating the Extractor.
One person at the controls to operate
roller engage lever and the truck driver
in the tractor cab to monitor the opera-
tion. The truck driver is then available to
shut everything down if required.
NOTE
It is recommended that the truck
driver operate the tractor during the
loading/unloading operation.
IMPORTANT
Do not set park brake on tractor or leave
the transmission in gear. Extractor must
be able to move both the machine and
the tractor into the bag during operation.
Setting the park brake on the tractor will
prevent this.